Bloom

This is my blog post on the Sparkle N Sprinkle blog today

Products:

Happy Flowers Stamp Set

Tonic Love Arch Squares Die Set

Tooth Fairy Glitter

Cloud Nine Glitter

Nuvo Acorn Brown Ink

Nuvo Glue Pen Large

Tim Holtz Stamp Platform

Tear-ific Tape 1 1/2"

Tear-ific Tape 1/2"

Memento Ink

Hi there, Diane with you today to share a card I created with

an awesome die 'Tonic Love Arch Squares Die Set'.

This is a beautiful die and all the die cuts you see are from the set.

I first started by cutting the card base using the largest of the dies.

You can see I overlapped it at the top of my folded in half card stock.

It then created the card so it would open and wasn't cut apart.

My next step is a bit different, as I would of normally used 

Super Adhesive Sheets but ran out of them.

(I will be ordering them for sure in the near future) 

But, to save the day I used Tear-ific Tape 1 1/2"

and covered my die cut with it,

I  also used Tear-ific Tape 1/2" on the smaller die cut.

then using Tonic 5" Mini Scissors I carefully trimmed off the excess.

A little more time consuming and a little tricky, but it saved the day!

After the trimming was done, I then added Tooth Fairy glitter.

I love the names of the glitters, I sometimes buy just because of the names!

I did the exact same thing on the larger panel,

but this time used Cloud Nine glitter.

I stamped the flower from Happy Flowers stamp set

 with Memento ink using the Tim Holtz Stamp Platform, 

then colored with Copics.

The sentiment was stamped with Nuvo Acorn Brown ink

and I die cut a heart (again part of the love arch squares set).

coated it with Nuvo Glue Pen Large and added Cloud Nine glitter to that.

A pretty bow was added to finish.

Thank you for visiting with me today.